Please read these instructions thoroughly before use. Failure to follow instructions may
result in equipment damage or failure, losses, injury or death.
DANGER:
To avoid possible electric shock:
• If the power cord has been damaged, DO NOT operate, the ClearSolution™ G2 Filter should
be replaced.
• Prior to installation, inspect the quartz sleeve and UVC bulb to ensure there was no damage
during transportation.
• Close supervision is necessary when the unit is used by or near children.
WARNING:
To reduce the risk of electric shock:
• Connect only to a properly grounded receptacle, which is serviced by a Ground Fault Circuit
Interrupter and never remove the ground pin from the plug.
• Provide a “drip loop” for the power cord. This is a loop in the cord below the level of the
receptacle or plug that prevents water from traveling along the cord in the direction of
the receptacle.
• ALWAYS unplug the ClearSolution™ G2 Filter from power source when it is not in use, and
before installing, removing or servicing the ClearSolution™ G2 Filter components.
• If an extension cord is necessary, a cord with a proper rating should be used. A cord may
overheat if the cord is rated for less amperes or watts than the unit rating.
• DO NOT immerse the ClearSolution™ G2 Filter plug in water or attempt to use a wet plug.
• The ClearSolution™ G2 Filter is NOT suitable for use in swimming pools, swimming ponds, or
other situations where bodily contact is made with the water.
CAUTION:
To reduce the risk of equipment damage or failure:
• ALWAYS keep the ClearSolution™ G2 Filter completely submerged during operation for
proper cooling.
• DO NOT place ClearSolution™ G2 Filter near flammable or other dangerous materials or objects.
• DO NOT use the ClearSolution™ G2 Filter with fluids other than water.
• ALWAYS unplug the unit if there is no water running through it to prevent over heating.
• DO NOT operate during freezing conditions. Drain the ClearSolution™ G2 Filter and store in a
protected location.
• DO NOT operate the ClearSolution™ G2 Filter with a pump larger than the pump indicated
by the unit specifications. Operating with a pump larger than recommended can reduce the
UVC’s effectiveness or cause damage to the UVC and filter and will NOT be covered under
warranty.
The Pond Guy® is not responsible for equipment damage or failure, losses, injury or death
resulting from failure to follow safety precautions, misuse or abuse of equipment.
thepondguy.com | 866-POND-HELP (766-3435)
2
