USER GUIDE
–
Alpine Heel
Alpine Heel - USER GUIDE - June 2016
4
2.
Case 2: drill with the THE M drilling pattern
You can use the THE M drilling pattern if you already have mounted the MEIDJO bindings and you want to add the
alpine heel.
You will find the THE M drilling pattern at the end of this user guide .
Place the Meidjo binding heel in the up position (the red piece)
Remove the up heel of the binding (the metal piece allowing the up position of the touring mode)
Unscrew the 2 screws located on the back of the binding heel and remove them
Cut the drilling pattern and place it against the binding heel as
illustrated on the picture on the right. The ski center line must
be aligned with the drilling pattern center line.
Place the alpine heel on the binding heel and check that every hole
matches with the indication. Once it matches, tape the drilling
pattern to the ski.
3.
Drilling and tapping
Nota: Follow carefully the ski manufacturer's recommendations for the dimension of the drill. THE M Equipment
recommend a 3.6 Ø drill to get the best thread retention based on the minor diameter of the screw.
