USER GUIDE
–
Alpine Heel
Alpine Heel - USER GUIDE - June 2016
6
5.
MOUNTING THE ALPINE HEEL
1.
Put the glue into the 4 holes (case 1 and case 2)
2.
Fix the front of the alpine heel on the binding heel with 2 x
11,5mm screws. Use a PZ N°3 s crewdriver.
3.
Fix the back of the alpine heel with 5,5x14mm screws. Use a PZ
N°3 screwdriver.
4.
Place a shoe in the binding in the Telemark mode and check that the distance between the shoe and
the edge of the hooking pins is of 5mm when
they’re
in the backward position.
6.
USING THE ALPINE HEEL WITH BIGGER SHOES
You need to modify the settling at the back of the alpine heel by screwing until the
moving part is at the desired distance. Be careful to always let a 5mm distance
between the shoe and the edge of the hooking pins. Also note that the moving part
had been relocated alongside the screw.
This device therefore provides some freedom regarding the length of the shoe.
However,
the bindings were originally set for a specific shoe size. You can’t use a
shoe which exceed the original size of 2 shell sizes, meaning 4 to 5 shoe sizes.
5mm
5mm
