12
Enter ModBus Parameters
First
go to config (pulldown) and in the first tab named ‘Port Setup and Axis Selection’, in the lower
right of the screen, check the ‘ModBus Input/Output Support’ checkbox.
ModBus Plugin Supported and TCP ModBus support should NOT be checked.
Note; the port Addresses and Enabled checkboxes may be set differently on your system. Do not
reset them to match this image. Those are not associated with the
InTurn™ Controller.
Note:
Do not change your Kernel Speed
to match the image. It is also unrelated to the
InTurn™
Controller and will likely be different on your system.
Close and restart MACH3.
Second
, from the top of the MACH screen, go to
Function
Cfg’s
and
choose
Setup Serial ModBus Control
from the drop down.
Change the following:
Port Num
:
Enter the InTurn™ Communication port number for
your
controller
(as determined earlier in the Installation process)
