IMPORTANT:
To avoid damage to the fan and motor, always reinstall the filter before using the vac for dry
material pick-up. Take the dirty filter to a disposal container and gently brush away small
dirt particles that may be adhering to the filter material.
IMPORTANT:
After cleaning, check the filter for tears or small holes. Do not use a filter with holes or tears
in it. Even a small hole can allow a lot of dust to come out of your vac. Replace it
immediately.
INSTALLATION
Before installing the filter on the vac, clean the area of the lid so that the retainer band will
seal the bag against the lid and stop small particles from bypassing the filter bag.
If the filter is clean and not damaged, replace it on the filter cage. If it cannot be reused,
place a new filter over the filter cage.
Replace the retainer band around the filter. Make sure the retainer band is positioned on
the filter, and the filter completely covers the filter cage. Also, make sure the edges of the
filter are completely secured under the retainer band.
WARNING
Do not remove the filter cage and float. The float prevents liquid from entering the impeller
and damaging the motor. The cage prevents fingers from touching the moving impeller.
CLEANING
To clean the tank:
1.
Dump debris out.
2.
Wash tank thoroughly with warm water and mild soap.
3.
Wipe out with dry cloth.
STORAGE
Before storing your vacuum, the dust tank should be emptied and cleaned.
