The Handy 193821002, Operator'S Manual & Parts List

Page: 12 / 25

STEP 2 – THE BOTTOM DRUM
D
- Slide the bearing block on the shaft. Hold it in place with Ø42 spiral ring.
Carefully, and with two people, set the bottom drum with support arm onto the side supports of the
stand as shown, so that the bearing blocks slot into the channels provided by the side supports. The
larger diameter shaft should be at the leg end of the stand.
At each side, line up the holes in the side support with those in the bearing block and insert a M8x65
hex bolt from one side, then a flat washer, lock washer and nut from the other side. Tighten with a
M8 spanner.
STEP 3 – THE MIXING BLADES
E
- Mount the mixing blades inside the bottom drum loosely as shown - Two holes are provided at
the base of the drum into which a M8X20 bolt may be inserted from the outside. A rubber washer,
flat washer, lock washer and nut should be threaded on loosely on the inside. The rubber washer
should be placed under the blade down against the drum.
NOTE:
Two arrow labels are affixed on the upper drum and bottom drum to assist you in lining them
up to one another. If you have any difficulty in correctly positioning the mixing blades, it is helpful if
you temporarily mount the upper drum on the top of the bottom drum, rotating it so that the two
arrows line up.