Page 6 of 9
PREPARING THE UNIT FOR STAND-BY MODE
1. Place the unit on a flat surface and plug into AC outlet.
2. Remove the lid from the base unit.
3. Place the 2 freezer bottles and the lift-out basket into the unit.
4. Make sure the water level is above the fill line on the water reservoir.
5. Place the prepared bottle into the lift-out basket
NOTE:
Be sure to remove the
bottle’s hood or baby food jar’s lid first.
Recommended max chill time is 8 hours. Do not remove lid during
warming cycle as it will/may result in inaccurate warming.
It is not
recommended to warm/thaw frozen breastmilk in the warmer. Product is
not designed to warm bagged breastmilk…only in a bottle.
Do not place bottle/jar directly onto heating element.
Always use the lift-out basket when warming or sterilizing.
6. Replace lid onto the base unit. Lid must remain securely on the base unit
during use.
Line drawing showing proper placement of the freezer bottles and lift-out basket
Line drawing of a hand putting the lid on showing the front cut out lining up with the
water reservoir
Line drawing of the unit with water reservoir with a callout to the fill line
SETTING THE UNIT IN STANDBY MODE:
1. Turn the unit ON by pressing the power button down for 2 seconds
2. Using the up/down buttons, set the desired warming time
a. Use the provided chart to determine the recommended warming time
NOTE: The recommended warming times are not exact durations. Adjust
the warming times as desired.
b. For initial use, the LCD screen will read: 0:00. After using the unit for a
warming cycle, the unit will display the warming time used last. The
warming time can be adjusted up/down as desired (up to a max of 15
minutes).
NOTE
: In the On state, the unit is programed to alert you to potential
issues by displaying
and the remote will alert you by flashing alternate
blue/orange lights
The battery icon will flash if the remote battery level is low
An error message
“H2O” will appear on the LCD screen
if the water
reservoir needs to be filled
3. After 5 seconds from the last button pushed, the LCD screen will show two
circulating zeros 5 times, then will show set warming time, indicating that the
unit is in standby mode
NOTE:
The remote will pulse a soft blue light indicating the warmer is in
standby mode.
***Insert** warming times here for Bottles with ice packs/Bottles without ice packs/Baby
food/Sterilize/silicone
Line drawing showing where the warming time chart is (showing it being half way
pulled out)
Line drawing showing the LCD panel calling out up/down buttons AND the power
button
