6
Crisp & Clear
™
Audio Monitor
Monitor Setup
Parent Unit(s)
To operate with batteries:
1. Screw the antenna into the Parent Unit.
2. Loosen screw to release the battery compartment cover. Then lift the cover off
(for easier access, rotate belt clip away from battery cover.)
3. Insert three AA batteries. Position them so the + and - contacts are aligned with the
corresponding contacts on the battery compartment. Make sure the ribbon is placed
under the batteries to allow assistance in removing.
4. Place cover back on battery compartment and secure it by tightening screw.
5. When it’s time to change the batteries, the power indicator light will turn red. Replace
batteries with three new AA batteries at that time.
To operate with AC adapter:
Insert AC adapter plug into the jack on the side of the unit, then plug the adapter into an
electrical outlet.
CAUTION:
Always use the AC adapter supplied with this product. Do not use any other adapter.
Monitor could become damaged, and warranty would become void.
Child Unit
1. Position the Child Unit within approximately 6 feet of your child, but no closer than 3 feet.
WARNING:
Do not place Child Unit in crib or attach to crib.
(To prevent heat build-up, place on an open surface away from heat sources;
do not place in an enclosed space.)
2. Position antenna straight up as shown.
3. Insert the AC adapter plug into the jack on the side of the unit, then plug the adapter into
an electrical outlet.
For wall mounting (optional):
1. Securely fasten one #8 pan head wood screw on the wall (For best results, use a 3/4-inch
screw; mount in solid wood or use a screw wall anchor).
2. Leave the screw head protruding from the wall by at least 1/4-inch.
3. Press the adapter cord into the grooved channel on the back of the unit, making certain
to slide it under the holding clips.
4. Fit the screw head slot (on the back of the unit) over the screw head and slide the unit
down to seat it firmly.
5. Position antenna to the side.
6. To test the unit is securely mounted, press on its edges.
