Note:
if you break the beam whilst it’s auto aligning it
will automatically abort, reset by pressing the
left back
button and pressing
enter
to re-start auto alignment
the alignment could take up to 30 minutes or more
depending on how much aligning is required. Once com-
plete you will see a Align Complete notification, simply
press the
left back
button to exit and your
fire
beam is now
ready and commissioned
you will now see this screen. Air Quality may fluctuate
slightly around a couple of %.above and below 100
first you will see the signal power readings and receiver
sensitivity drop if the received signal reading is over 100%.
once at 100% or if the reading is under 100% the
fire
beam
will automatically move its X and Y axis until it is positioned
on the reflector. (
This operation could take 30 minutes or
more)
step
four.
testing
to test that the firebeam is aligned correctly you will need to carry out two tests.
Your
fire
beam has now been commissioned and tested.
1. a filter test for ‘
Fire
’
place the filter provided over the eyes of the
fire
beam.
having done this (after 10 seconds) the
red
fire LED will flash on
both the head and on the controller and the word FIRE will
replace NORMAL on the low level
controller display
2. a reflector test, to check that the beam is reflected
back from the reflector
cover the reflector completely within one second. If the beam is
correctly targeted on the reflector a fault condition will occur (after
10 seconds). A amber LED will flash on both the head and on the
controller, the word FAULT will appear
in the display
10
Summary of Contents for firebeam
Page 1: ...user guide issue 0025 05...
