background image

Electrical surges are by far the biggest cause of problems 

with electrical circuits. In order to help protect your 

investment, in case of a power surge or outage, use an 

electrical surge protection device (not included).

 
WARRANTY WARNING!
Do not open or tamper with the transformer, control 

box, motors, or remote control (with the exception of 

battery compartments). The product warranty will be 

void if these components are tampered with.

 
SMALL CHILDREN AND PETS
Immediately dispose of all packing materials as they can 

smother small children and pets. Do not allow any 

persons or pets under the bed. Children, convalescents, 

and disabled persons should not operate the bed 

without adult supervision.

 
HOSPITAL OR CONVALESCENT 
USE DISCLAIMER
Adjustable beds are designed and engineered for a 

lifestyle of in-home comfort and are not intended for 

hospital use for a bed-ridden patient on extended 

recovery. Adjustable beds are not equipped with bars to 

help patients get safely in and out of the bed and are not 

intended to be used around tent-type oxygen therapy or 

explosive gases.

PACEMAKER WARNING
The massagers in this bed produce mechanical 

vibrations that may activate a special sensor in your 

pacemaker that detects motion. This can fool the 

pacemaker into “thinking” you are engaged in some sort 

of physical activity and require a faster heart rate, and 

you may experience a sensation similar to when you are 

exercising. Consult your physician for further 

information.

 
PRODUCT RATINGS
The bed lift motors are not designed for continuous use 

of more than 2 minutes in an 18-minute period, or 

approximately 10% duty cycle. Any attempt to 

circumvent or exceed this rating will shorten the life 

expectancy of the product and may void the warranty.

WEIGHT UNITS
The limitation for this adjustable bed is 750lbs. The bed 

will structurally support this weight if it is evenly 

distributed across the head and foot sections. This 

product is not designed to support or lift this amount in 

the head or foot section alone. Exceeding this weight 

restriction could damage the bed and/or cause injury 

and void the warranty. Enter and exit the bed in a flat 

position and do not sit on the head or foot sections while 

in the raised position.

LIFTING AND LOWERING MECHANISMS AND 
MASSAGE UNITS
It is normal for the raising and lowering feature on the 

bed to emit a minimal humming sound during operation. 

The massage feature creates a vibrating hum during 

operation and the resonance will increase accordingly 

with a higher intensity motor setting.

LOCATION ENVIRONMENT
The level of sound experienced in a room is directly 

related to the environment within that location. A 

vibrating sound may be noticeable if the massagers are 

turned on in a room with hardwood floors. To reduce the 

resonance, place a piece of carpet or rubber caster cups 

under the legs. The rubber caster cups also prevent the 

bed from sliding when located on a smooth or hard 

surface flooring.
TO REDUCE THE RISK OF SHOCK, BURNS, 
FIRE, OR INJURY
Make sure the base is in a flat position and the vibrating 

motors are off before unplugging it from the power 

source. Always unplug the base from the electrical outlet 

before cleaning or servicing the base. If the cord or plug 

is damaged, discontinue use of the bed base and contact 

qualified service personnel for examination and repair.

 
FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules for 

residential use. Operation is subject to the following two 

conditions: (1) this device may not cause harmful 

interference, and (2) this device must accept any 

interference received, including interference that may 

cause undesired operation. Radio Frequency: 2.4 GHz. 

EMERGENCY BATTERY BACKUP
In the event that the base is stuck in an articulated 

position during a power outage, the battery backup in 

the transformer will return the base to a flat position. 

Batteries are not to be used for normal operation of the 

base. Install two 9-volt alkaline batteries into the 

battery-backing transformer as shown below. Use the 

reset button on the control box to return the base to a 

flat position.

WARNING

Attention: Read the following information before using this product. Failure to use a surge protection device could 

compromise safety or cause product malfunction and could void the electrical portion of your warranty.

Summary of Contents for ARISE 504 Series









Reviews: