Textron Ransomes CT445, Operator Instructions Manual

Page: 54 / 74

52
LUBRICATION AND MAINTENANCE
• Fill the fuel tank with No. 1 diesel fuel.
IMPORTANT: Do not use No.2 diesel fuel for
winter storage because of wax separation and
setting at low temperature.
6. Open the drain valve of radiator and engine
block. Flush the system, close the drain
valve, and fill with a 50/50 solution of
permanent antifreeze and clear water.
7. Remove the battery and clean it thoroughly.
Be sure that it is fully charged, and that the
electrolyte is at the proper level. Place it in
storage in a cool, dry place above freezing
temperature. The battery should be charged
periodically during storage.
8. Place blocking under the tractor axles to
remove the weight from the tires.
9. Cover the exhaust pipe opening.
10. Place pedal spacer between clutch pedal and
step plate to separate clutch disc from
flywheel, Figure 70.
Figure 70 Installing Pedal spacer
Tractors that have been placed in storage should be
completely serviced in the following manner before
using
1. Inflate the Tyres to the recommended
pressures, and remove the blocking.
2. Check the oil level in the engine crankcase,
power steering reservoir, the common sump
(for the hydraulic lift, transmission, rear axle)
and optional front wheel drive axle.
3. Install a fully-charged battery and remove the
exhaust cover, if other than a rain cap.
4. Check the cooling system for proper level of
50/50 solution of antifreeze and clear water.
5. Remove pedal spacer from between clutch
pedal and step plate.
6. Start the engine and allow it to idle a few
minutes. Be sure the engine is receiving
lubrication and that each control is functioning
correctly.
7. Drive the tractor without a load and check to
be sure it is operating satisfactorily.