Textron Jacobsen Super LF 1880 Fairway Mower with ROPS, Service & Repair Instructions

Page: 282 / 300

OPTIONS
13C-10
Reassembly
1. Press the new bearing into the housing.
2. Install the inner snap ring and press in the new
seal (lip to the inside).
3. Install the outer snap ring and spacer.
4. On the drive end install the spacer, square drive
key, and driven gear.
5. Install hardware on both ends, torque to 20 ft-lbs
(27 Nm).
Figure 13C-5. Groomer Shaft Assembly
Blade Repair
Check the condition of the blades and straighten bent
blades whenever practical. If the blades must be
replaced, proceed as described below.
Disassembly
1. Remove the groomer shaft assembly as described
in the Removal section.
2. On the motor end of the groomer shaft, remove
the capscrew, spacer, bearing housing, and bear-
ing adjustment nut.
3. Remove the blade, retaining the nut and spacer.
4. Remove the spacers and damaged blade(s) as
necessary.
CAUTION
Properly support the retainer to prevent damage.