Textron Jacobsen SLF530, Repair Manual

Page: 284 / 352

7-26 673831-Rev A
STEERING
7
4WD Option Rear Axle
Removal and Installation
See Figure 7-32.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
Figure 7-33
2. Remove the steering cylinder (1). (See “4WD Option
Steering Cylinder” on page 7-21.)
3. Lift the rear of the mower so the rear wheels are
approximately 2-3 in. (51-76 mm) off the
ground.Support the mower frame using jack stands.
4. Remove the rear wheels (2). (See “Rear Wheels” on
page 9-11.)
5. Remove the rear wheel motor (3). (See “Rear Wheel
Motor” on page 5-60.)
6. Remove and discard cotter pin (4).
7. Remove castle nut (5) and washer (6).

WARNING
8 . Support the rear axle (7).
9. Remove axle shaft ( 8 ) and axle plate (9).
10. Lower the rear axle (7) out of the mower frame.
11. Remove the tie rod assembly (10).
Installation Notes
• Install the rear axle assembly by reversing the order
of removal.
• Inspect all ball joints for wear or torn dust seals.
• Use a new cotter pin (4).
• Check hydraulic oil level. Add oil as needed.
• Start the machine and check for hydraulic leaks and
cylinder operation. Repair as necessary.
Prevent personal injury. Use a properly rated
lifting device. Always be sure the load is
balanced before lifting.
MAR0219
1
2
2
3
3
4
5
6
7
8
9
10