Textron Bell 206A Series, Maintenance Manual

Page: 135 / 234

BHT-206A/B-SERIES-MM-1
5-00-00
30 APR 2013 Rev. 14 Page 105 Export Classification C, ECCN EAR99
SCHEDULED INSPECTIONS
5-30. 1200-HOUR INSPECTION
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
DATE: __________________W.O. _____________________
FACILITY: __________________________________________
HELICOPTER S/N: ___________________________________
REGISTRY NO.: _____________________________________
TOTAL TIME:_______________________________________
SIGNATURE:_______________ _________________________
NOTE
This inspection must be accomplished every
1200 flight hours.
Chapter 67 CYCLIC CONTROL STICK
Chapter 67 1. Remove pilot and copilot, if installed, cyclic control sticks.
BHT-206B3-CR&O,
Chapter 67 2. Clean lower 4 inches (101.6 mm) of removed cyclic stick
tube(s) and inspect.
3. Visually inspect cyclic stick tubes for cracks with a
3X magnifying glass. Pay particular attention to the area
adjacent to the two slots in the tube where two bolts secure the
tube when installed in the pivot lever assembly.
BHT-206B3-CR&O,
BHT-ALL-SPM,
Chapter 6 4. If a crack is suspected, remove paint and thoroughly
inspect lower end of the cyclic stick tube(s) for cracking using
the fluorescent penetrant method.
5. If a crack is found, replace the cyclic stick tube with a
serviceable tube.
6. If no crack is found, inspect cyclic stick tube for mechanical
and corrosion damage as follows:
a. Damaged and repaired areas must be separated by
1.0 inch (25 mm) minimum.