Textron Specialized Vehicles TRACKER LX6 EFI, Repair And Service Manual

Page: 41 / 168

B
WHEELS AND TIRES
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
23
Repair and Service Manual
699324
WHEELS AND TIRES
Tools List Qty.
Lug Wrench, 3/4"......................................................... 1
Impact Wrench ............................................................ 1
Impact Socket, 3/4" ..................................................... 1
Torque Wrench, ft. lbs. ................................................ 1
To prevent injury caused by a bro-
ken socket, use only sockets
designed for impact wrench use.
Never use a conventional socket.
Tire condition should be inspected per the Periodic Ser-
vice Schedule. Inflation pressures should be checked
when the tires are cool. When removing wheels with an
impact wrench, use only impact sockets. Regular sockets
are not designed for impact pressures exerted by power
tools.
A tire explosion can cause severe
injury or death. Never exceed infla-
tion pressure rating on tire sidewall.
To prevent tire explosion, pressurize tire with small
amount of air applied intermittently to seat beads.
Never exceed the tire manufacturer’s recommenda-
tion when seating a bead. Protect face and eyes
from escaping air when removing valve core.
Use caution when inflating tires. Due to the low vol-
ume of these small tires, overinflation can occur in a
matter of seconds. Overinflation could cause the
tire to separate from the wheel or cause the tire to
explode, either of which could cause personal
injury.
Do not use low inflation pressure tires on any E-Z-
GO vehicle. Do not use any tire which has a recom-
mended inflation pressure less than the inflation
pressure recommended in Owner’s Manual
Use caution when inflating tires. Due to the low volume of
these small tires, over inflation can occur in a matter of
seconds. Over inflation could cause the tire to separate
from the rim or cause the tire to explode, either of which
could cause personal injury.
Tire inflation should be determined by the condition of the
terrain. See GENERAL SPECIFICATIONS section for
recommended tire inflation pressure. For outdoor applica-
tions with major use on grassy areas, the following should
be considered. On hard turf, it is desirable to have a
slightly higher inflation pressure. On very soft turf, a
lower pressure prevents tires from cutting into the turf.
For vehicles being used on paved or hard surfaces, tire
inflation pressure should be in the higher allowable range,
but under no condition should inflation pressure be higher
than recommended on tire sidewall. All four tires should
have the same pressure for optimum handling character-
istics. Be careful not to over inflate. Due to the low volume
of these small tires, over inflation can occur in a matter of
seconds. Be sure to install the valve dust cap after check-
ing or inflating.
Tire Repair
The vehicle is fitted with low pressure tubeless tires
mounted on one piece rims.
Generally, the most cost effective way to repair a flat tire
resulting from a puncture in the tread portion of the tire is
to use a commercial tire plug.
NOTICE: Tire plug tools and plugs are available at
most automotive parts outlets and have the advan-
tage of not requiring the tire be removed from the
wheel.
If the tire is flat, remove the wheel and inflate the tire to
the maximum recommended pressure for the tire.
Immerse the tire in water to locate the leak and mark with
chalk. Insert tire plug in accordance with manufacturer’s
specifications.
If tire is to be removed or mounted, the tire changing
machine manufacturer’s recommendations must be fol-
lowed in order to minimize possibility of personal injury.
To prevent injury, be
sure mounting/
demounting machine
is anchored to floor. Wear OSHA
approved safety equipment when
mounting/demounting tires.
Follow all instructions and safety warnings provided by
the mounting/demounting machine manufacturer.