inching control of rising and falling, and the latter is the distance
of each rising and falling in inching control. There are four values
for switching: 5mm, 1mm, 0.1mm and 0.03mm
，
press
to switch the
value.
④
Knife depth judgement
，
there are three methods, as shown bellow:
Method One:
A.
Rotate this part
of the oscillating knife cutting tool
till the knife is at the lowest position.
B.
When the tip of the knife just goes into the felt about 0.5-1mm, the
tool setting is completed,as shown bellow:
Method Two:
A.
Rotate this part
of the oscillating knife cutting tool
till the knife is at the lowest position.
B.
Drop the tool bar to the position 5mm from the tool tip to the table
top.
(Note: Pneumatic oscillating knife tool is 10mm)
C.
Press
,then press
.
D.
Place a piece of typing paper on the table and drag the paper by
hand.If the paper is just cut off,then the adjustment is done. If it
doesn
’
t cut off the paper,press
to adjust the knife depth till
Summary of Contents for XYZ 2518
Page 1: ...TEXI XYZ 2518 MANUAL...
