5
4
LMA4V Laminator Specification:
Rollers: 2 Roller (hot shoe)
Entry width: 236mm
Min lamination thickness: 100(2x50) micron
Max lamination thickness: 160 (2x80) micron
Min pouch size: Credit card size (54x86mm)
Max pouch size: A4 size (303 x 216mm)
Max lamination Thickness: 0.45mm, excluding the Pouch.
Lamination speed: 25cm / min
Warm-up: 3-5 minutes
Power consumption: 220 Watts
Input: AC 220-240V, 1.0amp
Dimensions: 330 x 118 x 88 mm (L x D x H)
ModelLMA4V
TypeLaminator
Compliant with:-
BS EN 60950-1: 2006 &
EMC - EN 55014-1: 2006
EN 55014-2: 1997+ A1
EN 61000-3-2: 2006
EN 61000-3-3: 2008
MADE IN CHINA
Visit our Website at www.texet.com , to see our full range of products.
Disposal:
UK: Waste Electrical products/batteries should not be disposed
of with household waste. Facilities exist, for your nearest
facilities see www.recycle-more.co.uk or in store for details.
TTA4-V A4 Paper Trimmer Instruction Manual
Thank you for choosing a Texet photo/paper trimmer.
Before operating the trimmer, please read and keep the instructions for reference.
Parts description: As per below picture indicates:
Cutting Head.
Working table base.
Accessible open / close cap for changing blade.
Cutting Ruler
Prescribed use
The rotary trimmer is designed for the creative cutting of paper, film and other suitable
soft materials. It
is
possible
to
cut
up
to 5 sheets (70g/mm
)
at
the
same
time.
Safety instructions
In case of any damage
caused by the failure to observe these operating instructions,
or any improper use or operation
,
or
the
failure
to
observe
the
safety
instructions
,
then the guarantee for this product
,
will
be
invalid
.
●
●
Do not overload the Paper trimmer. Do not insert more sheets or
stronger sheets than stated in the Technical data.
●
Do
not
touch
the
edge
of
the
blades
as they are very sharp
!
●
Please keep this operating manual for further reference!
●
If you pass this
device
on
to
third
parties
,
please forward this
operating manual as well.
Do not use the cutting head
to
carry
the
trimmer
.
Operation
Do not cut hard material such as metal strips, glass etc. Always operate the
device with both hands. Use the device on a stable, flat and even surface only.
Before each cut please
check
that the Blade in the cutting head is secure.
●
.
●
Push the cutting head to the top of the ruler.
●
Place the material to be cut under the cutting ruler and bring it into the required
position
.
Place the Paper Trimmer onto a non-slip surface
1
2
3
4
3
4
1
2
