Speech Dialler
Installation Manual
INS232
5
2. Installation
General
The
Speech Dialler
requires a 12V @100mA DC power source, which is normally
supplied by the auxiliary power output of an intruder alarm control panel. If the unit is
not connected to an alarm control panel then a suitable power supply will be required.
The unit is supplied with a 1.5 metre telephone lead, which plugs directly into any
standard telephone socket. It is therefore recommended that the unit be sited as near
to a telephone socket as possible. If this it not possible an approved BT extension
lead may be required or the unit can be hard wired to the telephone socket using the
appropriate cable.
Mounting
1.
Open the unit by carefully inserting a small flat-blade screwdriver into each slot
at the base of the unit. Gently push the screwdriver to ease the retaining clips
upward,
DO NOT LEVER OR TWIST
. Excessive force is
NOT
required.
2.
Remove the front flap and front cover and unplug the loudspeaker from the
main circuit board.
3.
Mount the
Speech Dialler
using at least three appropriate countersunk screws
(no larger than No. 6). A keyhole slot has been provided to assist mounting and
aid leveling.
4.
Pass the necessary cables into the base through the cable entries and then
secure the
Speech Dialler
base to wall.
The telephone cable must be routed into the base using either the top right
or bottom right knockout cable entry. A screw mount cable tie has been
provided to allow the telephone cable to be secured to the base of the unit.
The cable tie should be fitted to either the top or bottom right fixing holes.
#"
ukpanels.com
