background image

9

INS352-5

MADE IN ENGLAND

Regulatory Information

The Premier External detector is protected 

by UK & International Designs.

Premier is a Trademark of Texecom Ltd.

7. 

Auxiliary Input

With the Auxiliary input enabled (JP8), a second detector with a normally 
closed relay output can be connected to the Premier External detector to give 
directional detection.  The order of activation required to give an alarm signal is 
set by the direction jumper (JP9).
When this is set to ‘1st’ the auxiliary detector must be activated first followed 
by the Premier External detector within 1 minute to give a valid alarm signal.
With the jumper set to 2nd, the Premier External detector must be activated 
followed by the auxiliary detector within 1 minute.
If directional detection is not required, disable the auxiliary input using JP8. 

AUX

Premier External PIR

AUX

Premier External PIR

JP8

ON

JP9

ALARM

NO 

ALARM

1st

2nd

NO 

ALARM

NO 

ALARM

JP9

ALARM

NO 

ALARM

1st

2nd

OFF

Supplier: 

Texecom Ltd, St. Crispin Way, Haslingden, Lancashire, BB4 4PW, UK.

Weee Directive

: Products marked with this symbol cannot be disposed of as unsorted municipal 

waste in the European Union. For proper recycling, return this product to your local 
supplier upon the purchase of equivalent new equipment, or dispose of it at designated 
collection points. For more information see: www.recyclethis.info.

RoHs Directive: 

RoHS Compliant. Hereby, Texecom declares that this device does not 

contain lead, mercury, cadmium, hexavalent chromium, polybrominated biphenyls (PBB) 

or polybrominated depheny ethers (PBDE) in more than the percentage specified by EU directive, 
except exemptions stated in EU directive annex.

CE Directive:

 Hereby, Texecom declares that this device is in compliance with the essential   

requirements and other relevant provisions of Directive.

Maintenance:

 Test yearly by the installer

Warranty:

 2 year replacement warranty

Security grade: 

EN Grade 2  

Environmental class:

 Class IV 

Disclaimer:

 The Premier External TD is not a complete alarm system, but only its part. Therefore 

Texecom does not accept any responsibility or liability for any damage that is claimed to be a 
result of an incorrect functioning of the Premier External TD detector. Texecom reserves the right 
to change the specification without a prior notice.

Cer tificate Number: FM 35285

Summary of Contents for Premier External TD













Reviews: