www.ti.com
Software Overview
13
SLAU708 – March 2017
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
TAS5782M Evaluation Module
3.4
Direct I
2
C
The I/O tab in the Direct I
2
C has two sub sections. The Input section has the provision to enter the read or
write commands scripts. Clicking the Execute button will execute the commands written in the Input
section. The status of the execution is displayed in the Output section as shown in
Figure 13
.
The Checksum button on the right is used to compute the checksum value of a cfg file. Load a cfg file by
clicking the Checksum button and then the computed XOR and CRC checksum will show on the Output
section.
Figure 13. Direct I
2
C Page, I/O Tab
