Texas Instruments RM48 series, Technical Reference Manual

Page: 183 / 1759

www.ti.com
System and Peripheral Control Registers
183 SPNU503C – March 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
Architecture
2.5.2.8 Die Identification Register Upper Word (DIEIDH_REG1)
The DIEIDH_REG1 is a duplicate of DIEIDH, see Section 2.5.1.29 . The DIEIDH_REG1, shown in
Figure 2-66 and described in Table 2-81 , contains information about the die lot number.
Figure 2-66. Die Identification Register, Upper Word (DIEIDH_REG1) [offset = F4h]
31 24 23 16
Reserved LOT #
R-0 R-D
15 0
LOT #
R-D
LEGEND: R = Read only; - n = value after reset; D = value is device dependent
Table 2-81. Die Identification Register, Upper Word (DIEIDH_REG1) Field Descriptions
Bit Field Description
31-24 Reserved Reserved for TI use. Writes have no effect.
23-0 LOT # This read-only register contains the device lot number.
NOTE: Die Identification Information
The die identification information will vary from unit to unit. This information is programmed
by TI as part of the initial device test procedure.
2.5.2.9 Die Identification Register Lower Word (DIEIDL_REG2)
This register is shown in Figure 2-67 and described in Table 2-82 .
Figure 2-67. Die Identification Register, Lower Word (DIEIDL_REG2) [offset = F8h]
31 0
DIEIDL2
R-X
LEGEND: R = Read only; - n = value after reset; X = value is unchanged after reset
Table 2-82. Die Identification Register, Lower Word (DIEIDL_REG2) Field Descriptions
Bit Field Value Description
31-0 DIEIDL2(95-64) 0-FFFF FFFFh This read-only register contains the lower word (95:64) of the die ID information. The
contents of this register is reserved.