Texas Instruments LM76005QEVM, User Manual

Page: 2 / 19

2 Setup
This section describes the test points and connectors on the EVM and how to properly connect, set up, and use
the LM76005QEVM. Refer to
Figure 2-1 for a top view of the EVM and relative placement of the different test
points and connectors.
Figure 2-1. Top View of LM76005QEVM
2.1 Input/Output (I/O) Connector Description
VIN – Terminal on
J1 The power input terminal for the converter
VOUT – Terminal
on J2 The regulated output voltage for the converter
VIN_EMI – Terminal
on J6 Used to supply the input voltage through an on board LC filter (if one is needed for
conducted EMI/EMC measurement). The L1 and CBULK component pads are located on
the bottom side of the EVM. Refer to
Figure 3-1 for initial suggestion of component
values. J6 and LC filter are not populated on this EVM.
GND – Terminal on
J1, J2 and J6 The ground reference for the converter
EN – Testpoint Used to enable the converter by supplying a voltage greater than 1.2 V (typ) or just to
monitor the voltage on this pin whenever a resistor divider is in place (for precision enable
applications). The regulator is enabled when V
IN
> 3.5 V. This threshold can be calculated
by:
RENT
Enable _ Voltage VIH _ EN 1
RENB
§ ·
˜ ¨
¸
© ¹
(1)
Setup www.ti.com
2 LM76005QEVM User’s Guide SNVU694A – FEBRUARY 2020 – REVISED JULY 2020
Submit Document Feedback
Copyright © 2020 Texas Instruments Incorporated