Texas Instruments LM4910 Boomer, Manual

Page: 5 / 30

LM4910
www.ti.com SNAS151G – MAY 2004 – REVISED MARCH 2007
Electrical Characteristics V
DD
= 3V
(1) (2)
The following specifications apply for V
DD
= 3V, A
V
= 1, and 32 Ω load unless otherwise specified. Limits apply to T
A
= 25°C.
Symbol Parameter Conditions LM4910 Units
(Limits)
Typ Limit
(3) (4) (5)
I
DD
Quiescent Power Supply Current V
IN
= 0V, 32 Ω Load 3.3 6 mA (max)
I
SD
Standby Current V
SHUTDOWN
= GND 0.1 1.0 µA (max)
V
OS
Output Offset Voltage 5 30 mV (max)
P
O
Output Power THD = 1% (max); f = 1kHz 30 25 mW (min)
THD+N Total Harmonic Dist Noise P
O
= 25mW
rms
; f = 1kHz 0.3 %
65 (f = 217
V
RIPPLE
= 200mV
p-p
sinewave Hz)
PSRR Power Supply Rejection Ratio dB
Input terminated with 10 Ω to ground 65 (f =
1kHz)
V
IH
Shutdown Input Voltage High 1.5 V (min)
V
IL
Shutdown Input Voltage Low 0.4 V (max)
(1) All voltages are measured with respect to the GND pin unless otherwise specified.
(2) Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for
which the device is functional but do not guarantee specific performance limits. Electrical Characteristics state DC and AC electrical
specifications under particular test conditions which guarantee specific performance limits. This assumes that the device is within the
Operating Ratings. Specifications are not guaranteed for parameters where no limit is given, however, the typical value is a good
indication of device performance.
(3) Typicals are measured at 25°C and represent the parametric norm.
(4) Limits are guaranteed to National's AOQL (Average Outgoing Quality Level).
(5) Datasheet min/max specification limits are guaranteed by design, test, or statistical analysis.
Copyright © 2004–2007, Texas Instruments Incorporated
Submit Documentation Feedback 5
Product Folder Links: LM4910