Multiple EVMs
Open
Opens saved register settings and
defaults
Save
Saves all current register settings and
defaults
Register Settings
Show LDC10xx Register Settings
Configuration
Show EVM Configuration
Streaming
Show Streaming Section
3.5
Multiple EVMs
To connect multiple EVMs to a single host, multiple instances of the GUI should be launched. Each EVM
will interface to only one instance of the GUI; multiple instances cannot connect to the same EVM. Use
the following procedure to setup multiple EVMs:
1. Connect the desired number of EVMs to the available USB ports.
2. Open one instance of the GUI, note the COM port number at the top of the GUI. This EVM is the
highest priority. Remove and replace each EVM individually until the COM port number changes. Note
the new COM port number.
3. This EVM is the next highest priority. Repeat this process until no EVMs are connected and the EVM
with the lowest priority has been identified.
4. When all of the EVMs are to be used simultaneously, open one GUI for each EVM and plug in the
EVMs from lowest priority to highest priority – each will claim their own instance of GUI.
3.6
General Configuration
In the configuration section, all registers of the device can be accessed. To access this section, streaming
must be stopped.
8
Inductive Sensing GUI User Guide
SNAU150A – September 2013 – Revised March 2014
Copyright © 2013–2014, Texas Instruments Incorporated