Setting Up the Hardware
2-2
2.1
Setting Up the Hardware
To set up the hardware provided with the DVEVM, use the steps in the
sections that follow. You may skip sections if you do not need to access
a particular peripheral. For example, if you do not need to use the serial
cable, skip that section.
1) The DVEVM is sensitive to static discharges.
Use a grounding strap or other device to
prevent damaging the board.
Be sure to connect communication cables
before applying power to any equipment.
2) If you use PAL video, set switch 10 on the S3 (USER) bank of
switches to On. If you use NTSC video, set this switch to Off. See
Figure 1–1 for S3 switch bank location.
3) Connect the yellow video cable to the upper-right Video Out jack on
the DVEVM and the LCD display Video Input as shown below.
Changing the Video Input/Output Methods
for
information about using S-Video or Component video.
Summary of Contents for DVEVM
Page 1: ...DVEVM Getting Started Guide Literature Number SPRUE66A August 2006...
Page 14: ...1 6...
Page 70: ...Index 4...