Quick Start Guide
4
SNLU220 – December 2016
Copyright © 2016, Texas Instruments Incorporated
Using the DS90UB934-Q1EVM Evaluation Module
2
Quick Start Guide
1. Connect mini USB J5 to USB port for register programming
2.
Optional :
Connect an external I
2
C host adapter I
2
C signals on J4 port for register programming
3. Configure switches S1 and SW1 to set operating modes of the device
4. Configure VFEED power supply for each channel on J14, J16, J32, J33, and J35 headers
5. Plug a sensor into the DS90UB913A/DS90UB933 serializer boards to create four camera modules
6. Connect the camera module to channels 1 or 2 using coax cables on CN1 or CN2
7. Interface parallel LVCMOS output signals (J2) to application processor
8. Provide power to board on J24 (+12VDC)
(a) Optional 5-V DC power supply on J11 (remove jumper on J12 if +5VDC applied to J11)
(b) Optional 1.8-V DC power supply on J28
(c) Optional 3.3-V DC power supply on J29
9. For details of pin-names and pin-functions, refer to the
data sheet.
Figure 2. Interfacing to the EVM