Texas Instruments DLP3030-Q1, User Manual

Page: 9 / 20

9 DLPU065 – November 2017
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
Getting Started
Chapter 2
DLPU065 – November 2017
Getting Started
2.1 Section Overview
This section will provide step-by-step instructions to display an image using the EVM. Section 2.2 contains
EVM physical assembly instructions, Section 2.3 contains electrical power-up instructions, Section 2.4
contains EVM GUI installation and use, and Section 2.5 contains connector pinout tables.
2.2 Kit Assembly
Table 2-1. Required Tools and Items
ITEM NO. ITEM
1 M3 Allen Wrench
2 M4 Allen Wrench
3 Phillips Screw Driver
4 12 V @ 3-A Power Supply
2.2.1 Instructions to Assemble EVM
• Install the DMD Ribbon Cable between the DMD Board and the Formatter Board, ensuring that it is
inserted evenly across the entire connector, as shown on the right in
Figure 2-1 .
Note: This connector has a latch that must be lifted when installing the cable and then clamped down
to secure its position.
Figure 2-1. DMD Flex Cable Installation Alignment