Texas Instruments BOOSTXL-TPS65218, User Manual

Page: 1 / 38

1 SLVUBH5 – October 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
BOOSTXL-TPS65218 EVM User's Guide
User's Guide
SLVUBH5 – October 2018
BOOSTXL-TPS65218 EVM User's Guide
The BOOSTXL-TPS65218 is a BoosterPack evaluation module (EVM) for programming samples of the
TPS65218D0 power management IC (PMIC) with user-defined values for output voltage, sequence timing,
and other critical parameters. Modifying these parameters using the BOOSTXL-TPS65218 allows for rapid
prototyping and quick time to market when using the TPS65218D0 PMIC to provide power to a variety of
processors and FPGAs.
This document provides a description of how to setup the EVM and re-program the EEPROM memory of
the TPS65218D0 devices using the BOOSTXL-TPS65218 BoosterPack, an MSP430F5529 LaunchPad,
and the IPG-UI software. The steps in this document describe the procedure for programming samples of
the TPS65218D0 installed in the socket of the BOOSTXL-TPS65218 printed circuit board (PCB).
Contents
1 Introduction
..................................................................................................................
2
2 Getting Started
..............................................................................................................
4
3 EVM Operation
..............................................................................................................
8
Appendix A Software Instructions
..............................................................................................
10
Appendix B EVM Documentation
..............................................................................................
24
List of Figures
1 BOOSTXL-TPS65218 Printed Circuit Board (Top View)
...............................................................
3
2 BOOSTXL-TPS65218 and MSP430F5529 LaunchPad Connected
..................................................
4
3 BOOSTXL-TPS65218 BoosterPack and MSP430F5529 LaunchPad Block Diagram
.............................
5
4 BOOSTXL-TPS65218 with Socket Open
.................................................................................
9
5 Run the IPG-UI Software
.................................................................................................
10
6 Successful Connection Between Computer and USB2ANY
..........................................................
10
7 Creating New IPG-UI Project for the TPS65218D0
...................................................................
11
8 TPS65218D0 Project Introduction Tab in IPG-UI
......................................................................
11
9 Successful Write Access to TPS65218D0 Notification
................................................................
12
10 Failed GUI Communication to TPS65218D0 Notification
............................................................
12
11 Auto Password Write Enabled
............................................................................................
13
12 DCDC1 Register, Default Value
..........................................................................................
13
13 Disable GO Bit in SLEW Register
.......................................................................................
14
14 Modifying DCDC1 Register Value
.......................................................................................
15
15 EEPROM-Backed Registers of the TPS65218D0
.....................................................................
16
16 TPS65218D0 Re-Programming Example Block Diagram
............................................................
17
17 EEPROM Not Changed (EE Bit = 0b) in Status Register
.............................................................
17
18 Modifying CONFIG1 and CONFIG2 Register Values
.................................................................
18
19 Modifying DCDC2-4 and LDO1 Register Values
......................................................................
19
20 Modifying Sequence (SEQ3-4, SEQ6) Registers
......................................................................
20
21 Manually Writing PASSWORD Sequence to Re-Program EEPROM
...............................................
20
22 Automatically Writing PASSWORD Sequence to Re-Program EEPROM
..........................................
21
23 Interrupt for Successful Programming in INT1
.........................................................................
21
24 Registers 0x05-0x26 After Successful Re-Programming, EEPROM Changed (EE Bit = 1b) in Status
Register
.....................................................................................................................
22