PDK Kit Setup
7.3
Configuring the ADS8860EVM-PDK Hardware
The ADS8860EVM-PDK contains both the ADS8860EVM and the MMB0 motherboard; however, the
devices may be shipped unconnected or configured incorrectly. Follow these steps to verify that the
ADS8860EVM-PDK kit is properly configured and connected:
Step 1.
Unpack the ADS8860EVM-PDK kit.
Step 2.
Set J12 to closed, J13A to open, and J13B to closed on the MMB0, as shown in
.
•
J12 must be closed. This setting allows the wall supply to power-up the MMB0 and
ADS8860EVM through J2 (6-VDC input), and regulate down to 5 V, 3.3 V.
•
J13B must be closed. This setting connects the 5-V analog power supply with the 5-V
digital power supply.
•
J13A must be opened. This setting allows the 5-V analog power supply to be regulated
on board.
Figure 7. MMB0 Motherboard Jumper Configuration
Step 3.
Set JP1:2–3, JP2:2–3, JP3:open, and JP4:closed on the ADS8860EVM, as shown in
Figure 8. ADS8860EVM Jumper Configuration
10
ADS8860EVM-PDK
SBAU213 – September 2013
Copyright © 2013, Texas Instruments Incorporated