3-1
Digital Interface
The ADS8383EVM is designed for easy interfacing to multiple platforms.
Samtec part numbers SSW−110−22−F−D−VS−K and TSM−110−01−T−DV−P
provide a convenient dual row header/socket combination at P2 and P3.
Consult Samtec at
www.samtec.com
or 1−800−SAMTEC−9 for a variety of
mating connector options.
Table 3−1. Pinout for Parallel Control Connector P2
Connector.Pin
Signal
Description
P2.1
DC_CS
Daughter card Board Select pin
P2.3
P2.5
P2.7
A0
Address line from processor
P2.9
A1
Address line from processor
P2.11
A2
Address line from processor
P2.13
P2.15
P2.17
P2.19
INTc
Set jumper W3 to select BUSY or inverted signal
to be applied to this pin.
Note:
All even numbered pins of P2 are tied to DGND.
Read (RD) and conversion start (CONVST) signals to the converter can be
assigned to two different addresses in memory via jumper settings. This allows
for the stacking of up to two ADS8383EVMs into processor memory. See
Table 3−2 for jumper settings. Note, the evaluation module does not allow chip
select (CS) line of the converter to be assigned to different memory locations.
It is therefore suggested the CS line be grounded or wired to an appropriate
signal of the processor.
Chapter 3