Texas Instruments ADC31JB68, User Manual, Page: 12 / 20

Software Description
www.ti.com
12 SLAU630A – August 2015 – Revised August 2016
Submit Documentation Feedback
Copyright © 2015–2016, Texas Instruments Incorporated
ADC31JB68 Evaluation Module
4.2 Low Level View
The Low Level View tab, shown in Figure 6 , allows configuration of the devices at the bit and field level. At
any time, the controls described in Table 5 may be used to configure or read from the device.
Table 5. Low Level View Controls
Control Description
Register Map Displays the devices on the EVM, the registers for those devices, and the states of the
registers:
• Selecting a register field allows bit manipulation in the Register Data section.
• The Value column shows the value of the register at the time the GUI was last updated
due to a read or write event.
Write Register Button Write to the register highlighted in the Register Map with the value in the Write Data field.
This button must be clicked after changing bits in the register data section.
Write All Button Update all registers shown in the Register Map with the values shown in the Register Map
summary
Read Register Button Read from the register highlighted in the Register Map and display the results in the Value
column
Read All Button Read from all registers in the Register Map and display current state of hardware. Also
updates the controls in the other tabs.
Load Config Button Load a configuration file from disk and write the registers in the file
Save Config Button Save a configuration file to disk that contains the current register configuration
Register Data Cluster Manipulate individual accessible bits of the register highlighted in the Register Map
Generic Read/Write Register Buttons Perform a generic read or write command to the device shown in the Block drop-down
box using the Address and Write Data information
Figure 6. Low Level View Tab