• Impaq 6000
11
You can use the four IP
6000
FR speakers in any arrange-
ment as front or rear, left or right speakers and connect
them with the corresponding terminals 32, 33, 35, 36.
You can connect the center speaker IP 6000 C with the
terminal 34.
Turn the connector terminals on the subwoofer and the
speakers counterclockwise until loose. Run the stripped
cable into the hole that is now visible. Turn the terminal
clockwise. The cable has now been clamped into place.
Speaker stands
Front/rear speakers
The four front/rear speakers have been prepared for
mounting on the enclosed base plates.
Screw the base plate onto the bottom of the speaker
1.
cabinet with the enclosed bolts.
Attach the plastic disc onto the bottom of the base
2.
plate.
Center speaker
The center speaker rests on an anti-slip wedge-shaped
base.
Remove the protective strip from the base.
1.
Place the base in the desired location with the taller
2.
side to the front.
Place the speakers on the base.
3.
Subwoofer and television
Connect the subwoofer and a television with the DVD
preceiver using two signal lines.
The television must be equipped with a HDMI input.
Make sure that the devices are deactivated.
1.
Connect the multi channel out
2.
27
of the DVD preceiver
and DVD preceiver in
40
of the subwoofer with the
multi-channel audio cable
.
Connect the HDMI out
3.
20
of the DVD preceiver and
the HDMI input of the television with the HDMI cable
.
Note: Set the television input to HDMI (see the televi-
sion operating instructions).
91339 GB 20100111.indd 11
91339 GB 20100111.indd 11
11.01.2010 14:09:27 Uhr
11.01.2010 14:09:27 Uhr
