8
• Concept C 200
Setup and connection
Setup location
• Preferably, the room, where you plan to use a
Concept C 200
, should not be larger than 25 sqm.
• Select a stable, level base.
• Make sure that the environment is clean and free from
dust.
• Avoid placing the unit close to sources of heat or in
direct sunlight.
• Arrange the connecting cables so that they do not
pose a trip hazard.
• Do not place any heavy objects on top of the cables
or units.
Subwoofer
In general, you can position the subwoofer anywhere on
the floor in the room. Positioning the subwoofer between
the two front satellites is often beneficial. However, it is
not absolutely necessary that it be situated between the
satellite speakers as our ears are not capable of directly
locating the source of bass tones.
There should be at least 30 cm of space in front of the
bass speaker
2
and the reflex opening
3
as consider-
able air movement is produced around these openings at
higher volumes.
Satellite speakers
For the best possible sound quality, you should
• set up the left and right speaker at equal distances
from your preferred sitting position;
• set up the speakers at ear level;
• position the speakers on a shelf so that their front panel
is flush with the front edge of the shelf;
• do not cover the speakers with fabrics or objects.
You can set up the satellite speakers using the stands
included in the product contents or mount them directly
on the wall.
Table stand assembly
Insert the screw
d
through
the top hole of the table
stand
c
and turn the screw
into the threaded bush-
ing
11
on the back of the
speaker. Do not over tighten
the screw. The connectors of
the speaker cord are now
covered by the table stand
– to connect them later on,
loosen the screw somewhat
and turn the table stand to
the side.
d
c
Wall mounting
You will need the following materials for wall mounting:
• one screw for each speaker, 4 x 40 mm
(screw head = ø 9 mm)
• for rock walls, one dowel for each speaker (ø 5 mm)
Danger
Danger of damage and electric shock!
Proceed with care when mounting the unit on
the wall and follow the instructions below.
• The
speakers may
only be mounted on the wall by
properly qualified persons.
• The unit may only be mounted on a suitable, solid wall.
If mounting on plasterboard walls special dowels or
fixings may be required. Seek the advice of an expert.
• Ensure that no cords or pipes are located at the
desired mounting point. Before drilling and tightening
the screws, check the applicable areas with a metal
detector.
Drive the screw into the wall and hang the speaker with
the mounting hole
10
on the screw.
Connecting the satellites
To connect the satellite speakers, use high-quality,
two-core speaker cable with a diameter of at least 1.5
mm
2
and if possible, a banana plug for the subwoofer.
You can order them both as a set in our webshop
(www.teufelaudio.com) in the “Accessories” area.
7
12
12
The connector terminals
7
“SPEAKER OUT” for the right
(“Right ”) and left (“Left ”) speakers are located on the
back of the subwoofer.
The connector terminals
12
are located on the back of
the satellite speakers.
The terminals are marked in red (+) and black (-) respec-
tively.
Observe the correct polarity!
Connect the like-coloured terminals with one
another. Otherwise, the sound quality will
suffer. The cores of the speaker cable are marked with
different colours or shapes.
