16
• Cinebar 52 THX
Subwoofer CB 52 SW
Turning the subwoofer on and off
• You can turn the subwoofer on and off with the
mains switch
(29)
.
Once it has been activated, the power LED
(27)
will
turn green. The subwoofer is in the power mode.
Setting the subwoofer
•
AUTO• ON
switch
(26)
– Switch position
AUTO
: The subwoofer switches to
standby if it doesn't receive a signal for approx.
20 minutes.
Then the power LED
(27)
will illuminate in red.
When the Cinebar 52 THX is activated, the
subwoofer receives a signal again and switches
back into operating mode.
– Switch position
ON
:
The subwoofer stays in the operating mode even
if it does not receive a signal.
•
Volume
control
(28)
You can set the subwoofer volume with this control.
You can also use the
SUB
button
(18)
on the re-
mote control to adjust the subwoofer volume.
26
27 28
29
Care and cleaning
• Ideally, you should remove dust or small amounts of
dirt with a dry, smooth leather cloth.
• Use a damp cloth to rub off stubborn dirt. Make
sure that no liquid penetrates the housing.
• Then immediately wipe the damp surfaces off with
a soft cloth without applying pressure.
Note
Risk of damage
!
Using the wrong cleaning agents may damage the
delicate surface of the case.
• If possible, only use plain water without any
additives. In case of stubborn marks, a mild soap
solution may be used.
• In no circumstances should caustic cleaning
products, white spirit, thinners, petrol or similar
be used for cleaning.
Summary of Contents for Cinebar 52 THX
Page 19: ......
