11
• Cinebar 52 THX
Setup/wall mounting
Setup location
Cinebar 52 THX
The space under the TV set is an ideal location.
Hang the Cinebar 52 THX either directly on the wall or
use the stand
b
to set it up under the television.
Subwoofer CB 52 SW
You should also place the subwoofer on the floor as
close as possible to the television. However, you can
also set it up at another location in the room as the
human ear is unable to localise low tones.
However, do not set it up in the corner of the room as
this may result in uncontrollable frequency rises.
Location tips
• Select a stable, level base.
In case of wall mounting, follow the instructions in
the next chapter.
• Make sure that the environment is clean and free
from dust.
• Select a location away from heat sources and direct
sunlight.
• Lay the connector cable so that it does not pose a
tripping hazard.
• Do not place any heavy objects on the cable or the
devices.
Wall mounting
You will need the following material to mount the
speaker on a solid stone wall:
• 2 x dowels (ø 8 mm)
• 2 x screws, 5 x 50 mm
(screw head = ø approx. 10 mm)
NOTE
Proceed with care when mounting the product on
the wall and follow the instructions below.
• Only qualified persons may mount the
Cinebar 52 THX on the wall.
• The product may only be mounted on a suitable,
solid wall. Special dowels or anchors may be
necessary when mounting the product on light-
weight walls. Consult a qualified professional in
this case.
CAUTION
• Make sure that there are no cables or pipes in the
drilling areas. Before you drill, use a metal detec-
tor to check the applicable areas. Otherwise there
is a risk of electrocution/short-circuiting!
1. Space the holes in the wall at a distance of 54.75
cm apart (corresponding to the distance between
the two mounting profiles where you would like to
mount the Cinebar 52 THX). Use a ruler, pencil and
spirit-level for this.
2. Use a metal detector to check the drill areas. If
necessary, select another area for mounting the
speakers.
3. Use a 8 mm rock drill to drill holes, which are ap-
prox. 45 mm deep, at the marked positions.
4. Insert the 2 dowels (ø 8 mm) all the way in the drill
holes.
5. Screw one screw (5 x 50 mm) into each dowel until
there is approx. 4 mm of space between the wall
and the screw head.
6
6. Press the Cinebar 52 THX up against the wall so
that the screws vanish in the keyhole openings
(6)
. Now pull the Cinebar 52 THX down so that the
screws slip into the small slot.
7. If applicable, screw the screws further in or out until
the Cinebar 52 THX is securely mounted on the
wall.
Summary of Contents for Cinebar 52 THX
Page 19: ......
