28
INsTAllATION
© TESVOLT We reserve the right to make technical changes. Version RD.TI.015.E.ENG_Installation_Manual_TS48V_v.C.01 Last revised 06/2020
2
Cabinet extension for TS cabinet only:
Temporarily remove the
rear panel from the right-hand cabinet. Now remove the brackets
of the previously dismantled side panels on both halves of the
cabinet. Then refit the rear panel of the right-hand cabinet.
Prepare the extension cabinet according to section “6.1 Setting
up the cabinet” on page 25 et seq.
3
Cabinet extension for TS cabinet only:
All six baying connectors
K.1
can now be fitted to connect the two halves of the cabinets.
The baying connectors are located on the vertical cabinet frame
profiles at the bottom, in the middle, and at the top. To do this,
firstly place two ST5.5 x 13 pan head screws
K.2
in the diago-
nally converging extended holes with the bent end of the baying
connector at the top. For now, tighten the screws hand-tight only.
4
Cabinet extension for TS cabinet only:
Once all the baying con-
nectors have been pre-fitted, take a hammer and carefully tap
down each baying connector in turn. This reduces the distance
between the screws and pulls the two halves of the cabinet
together. Stop when the two ST5.5 x 13 pan head screws
K.2
are
at the upper end of the extended holes in the baying connector.
Now fully tighten the two pan head screws.
5
Cabinet extension for TS cabinet only:
Fit two further ST5.5 x 13
pan head screws
K.2
in the small holes in the baying connector.
6
Cabinet extension for VX cabinet only:
Once the side panel has
been removed, take out the cage nuts which held it in place.
