TESTO Smart Probes 115i, Instruction Manual

Page: 9 / 17

2.9 Applications
2.9.1
Select “Volume Flow (Outlet)”
Smart Probes: t405i or t410i
Optional: t115i, t510i, t605i, t905i
1. Press and select Edit view

see
“2.5 Settings view”
2. Press and select Configure measurement

Single measurement

Press to make your first measurement

Press to start a new measurement and again
make another measurement

Can also be done by pressing the button on the Probe

Multi-point measurement

Press to make a first measurement. A small number
appears on the top of the screen.

Can also be done by pressing the button on the Probe

After point measurements, click to end the
measurement and get an average result of your point
measurements

Press to start a new measurement

Timed-average measurement

Press to start your measurement. Time starts to run on the top of the screen.

Press to pause your measurement and to continue

Can also be done by pressing the button on the Probe

Press to end your measurement. Results are displayed as an average over the
measured time.

Press to start a new measurement

Parameterization of the outlet for volume flow measurement

Rectangular (Length/Width)

Round (Diameter)

Select the K-Factor

Activate/ Deactivate the Funnel factor in case of a combination with a testovent 415 funnel

Select Return air or Supply air

The calculated total volume flow can be added in the report
3. Press and select Pressure setting

Set your ambient pressure to calculate the right reference value for an accurate
measurement
2.9.2
Select “Volume Flow (Duct)”
Smart Probes: t405i or t510i
Optional: t115i, t410i, t605i, t905i

See (Volume Flow (Outlet)