Tesla WD490MW, User Manual, Page: 22 / 190

22
ENG
Display
❽
Program
indicator
Intensive
Heavily soiled items include pots and pans. With dried on food.
Universal
For normally soiled loads, such as pots, plates, glasses and lightly soiled pans.
ECO
This is the standard program suitable for normally soiled loads, such as pots,
plates, glasses and lightly soiled pans.
Glass
For lightly soiled crockery and glass.
90 Min
For normally soiled loads that need quick wash.
Rapid
A shorter wash for lightly soiled loads that do not need drying.
Pre-Wash
To rinse dishes that you plan to wash later that day.
❾
Warning
indicator
Rinse Aid
If the indicator is lit, it means the dishwasher is low on dishwasher rinse aid
and requires a refill.
Salt
If the indicator is lit, it means the dishwasher is low on dishwasher salt and
needs to be refilled.
Water Faucet
If the “ ” indicator is lit, it means the water faucet close
❿
Screen To show the remaining program time and delay time, error code etc.
Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would have a detrimental or
adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority
can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed based on the hardness of the
water used. This is intended to optimize and customize the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Open the door and switch on the appliance;
2. Within 60 seconds after the appliance was switched on press the Program button for more than 5 seconds to
enter the water softener setting mode.
3. Press the Program button again to select the proper set according to your local environment, the setting will
change in the following sequence: H1->H2->H3->H4->H5->H6;
4. Press the Power button to end the setting mode.