Let the HEPA filter dry thoroughly.
Never install a wet HEPA filter in the robotic vacuum cleaner!
SENSORS - clean once a week
Clean once a week four cliff sensors (
G
) and a wall following sensor (
F
) with a soft, dry cloth. Verify that the front bumper below which the
impact sensors (
E
) are located is not blocked. Also clean the laser range sensor (
C
).
MAIN CENTRAL CLEANING BRUSH AND SIDE CLEANING BRUSH - clean once a week
Remove the main center cleaning brush by pressing both tabs on the brush cover. Use a cleaning tool to remove hair tangled in the main brush.
Keep the center cleaning brush free of hair, dust, cotton, etc.
Check both side cleaning brushes together with the air intake opening at least once a week to remove hair and other debris from them.
FRONT WHEEL - clean once a week
Keep it free of hair and dust. Remove the center guide from the vacuum cleaner, also clean the wheel axis and then reinstall it into the robotic
vacuum cleaner.
CHARGING CONTACTS AND CHARGING BASE - clean once every 14 days
Clean the contacts on the front of the robotic vacuum cleaner and the contacts on the charging base with a soft cloth.
Laser safety
The robotic vacuum laser sensor meets IEC 60825-1: 2014 (third edition) for Class I laser equipment.
Battery
TESLA The RoboStar iQ500 features a state-of-the-art high-capacity Li-Ion battery, with no memory effect, so there's no need to worry about
recharging and discharging the battery.
Robotic vacuum cleaner RESET
If there is no response after pressing the buttons on the robotic vacuum cleaner or the robotic vacuum cleaner behaves differently than it
should, check that the battery is fully charged. You can also reset the robotic vacuum cleaner by pressing the reset button located under the top
cover.
