5.
Tube
13. Handle
6.
Turbo brush
14. Battery lock
7.
HEPA filter
15. Charging port 2
8.
Stainless steel filter
16. Small turbo brush
BATTERY CHARGING
Make sure the vacuum cleaner is switched off. Plug the power adapter into an electrical outlet, and
then plug the adapter connector into one of the two charging ports on the vacuum cleaner. During
charging, the blue light flashes, it lights up permanently when the battery is fully charged.
Avoid completely discharging the battery, if the red light starts flashing during cleaning, charge the
battery immediately.
VACUUM CLEANER ASSEMBLY
1.
Before using the appliance, turn the dust container to the position corresponding to the „O“ mark
and check that both filters are inserted.
2.
Turn the dirt tank to the „lock“ position.
3.
Install the tube (side without button) in the dirt tank.
4.
Install the turbo brush into the tube (button side).
5.
Press the „On/Off“ button to start cleaning. Press the „+/-“ button again to increase performance
- „Turbo“ mode. Press the „+/-“ button again to switch the power to „Standard“ mode. To switch
off the device, press the „On/Off“ button again.
6.
Attach the hanger firmly to the wall at a height of about 1 meter from the ground and near the
Summary of Contents for PureStar E40
Page 1: ...TESLA PureStar E40 ...
