![background image](http://html1.mh-extra.com/html/tesla/nikolacool-te-pt-12khc-blg/nikolacool-te-pt-12khc-blg_instructions-for-user_1091102013.webp)
12
Duct installation
Connect to or disconnect from the air conditioner duct with an adapter in accordance with the
operating mode of the device.
MODE
ACTION
COOLING (COOL)
HEATING (via heat pump, HEAT) AUTO
MANDATORY CONNECT
FAN (FAN)
DRYING (DRY)
HEATING (electric heating by TEN, HEAT)
CAN DISCONNECT
To connect the duct to the air conditioner, follow these steps:
1. Attach adapter I and adapter B to the ends of the duct as shown in the figure below.
2. To attach the duct to the air conditioner, align the hook of adapter I with the groove in the upper part of
the air outlet (located on the rear wall of the air conditioner), then lower the end of the duct down, as
shown in the figure on the right.
Installing a duct through a wall
NOTE: Only for models that are equipped with a wall-mounted exhaust adapter and a set of screws with
dowels for them).
1. Make a hole in the wall with the required diameter. Install a wall-mounted exhaust adapter on the
inside of the wall and be sure to secure it carefully with screws and dowels.
2. Connect the duct pipe to the wall exhaust adapter A.
NOTE: If you are not using the wall-mounted exhaust adapter, cover the hole in the wall with the adapter cover.
Depending on the situation, the duct pipe between the air conditioner and the hole in the wall may be
moderately compressed or stretched, but it is still desirable to minimize the duct length.
Attaching adapters to
the ends of the duct
Attaching the duct to
the air conditioner
Adapter hook
Groove at the top of the air
outlet
MOUNTING & INSTALLATION
Summary of Contents for NIKOLACOOL TE-PT-12KHC-BLG
Page 3: ...2 www tesla com np...