Qg 2 Multi-Sync Gateway User Guide
Command Reference
SJC-DEV7250-HR Rev. 1.14
17
Figure 9 System Info Command
4.3.2
System Upgrade Status Command
The Ts2 System Firmware Upgrade Status will be displayed if the upgrade was initiated previously from
either CLI or through Web User Interface.
Figure 10 System Upgrade Status Command
4.3.3
System Upgrade Start Command
The Ts2 System Upgrade Start command will perform firmware upgrade when the following inputs are
provided:
File transfer protocol, 1 or 2 (for FTP or SFTP).
Note:
Option 1 (FTP) has been deprecated and is not available anymore
Hostname, as either IP address or DNS name
File name containing the upgrade FW
Figure 11 System Upgrade Start Command
4.4
Network Commands
The Network Command operate on the Management port. The user can set up the network parameters
like enable/disable DHCP, static IPv4 address, netmask, and gateway addresses and display the current
setting of it. By factory default, the Management port network parameters are set statically as follows:
DHCP:
Disabled
IP Address:
192.168.2.100
