13
●
Body
●
Spatula block
●
Head
To wipe the head
inserting block, use a
soft dry cloth.
* A wet cloth must
not be used to wipe
the inserting block.
●
Water tank and water tank cap
[Safety device]
[Timing of charge]
[Cleaning]
●
If water enters the head inserting block, the power can no longer be turned on or off
owing to action of the safety device.
-> To take action for this case, with the head removed from the body, drain off the
water from the head and head inserting block, clean them, reinstall the head in
the initial position, and press the Power switch to restore to normal operation.
●
The low battery status is indicated by the battery lamp that flashes (when the power
is on) while consecutive short beeps are generated for 10 sec, and the power is
turned off automatically.
-> Immediately charge the battery.
●
This product can be used with AC 100 to 240 V power supply.
●
Make sure that the power is off and the power adapter has been removed. Then start
the cleaning.
●
Body, head, and spatula block
Wipe away dirt and grime using a soft dry cloth.
●
If it is difficult to remove dirt or grime from the body, soak a soft cloth in a soap-and-
water solution or a water-diluted neutral detergent, and wring well. Then, use this
cloth to wipe dirt and grime off the body.
Discard the tank water. Then, after drying naturally, reinstall the tank on the body.
How to Use
