Email: [email protected] www.terratekintl.com
ACL Group (Intl) Ltd
24
Guide Bearing Adjustment
(Fig.11)
Disconnect machine from the power source! Never make adjustments with the machine running!
Failure to comply may cause serious injury!
Note: Blade must already be tensioned and tracking properly.
1) For the upper blade guide, loosen two thumbscrews (F). For the lower blade guide, loosen
two setscrews (G) with the 3mm hex wrench provided.
3) Slide the adjustment shaft (H) to position each roller guide (I) approximately 1/16" behind the
gullets (teeth) of the saw blade. The roller guide (I) is mounted on a concentric shaft (H).
When the shaft is rotated, the relative position of the guide to the blade can be changed.
3) Rotate each adjustment shaft (H) to position the guides (I) within 1/32" of the saw blade.
5) Secure the roller guides (I) by tightening thumbscrews (F, upper guide) or setscrews
(G, lower guide).
Replacing the Poly V-Belt
(Fig.12)
Disconnect machine from the power source! Never make adjustments with the machine running!
Failure to comply may cause serious injury!
1) Open the upper and lower wheel cover doors.
2) Remove the saw blade.
3) Remove tension on the drive belt (A) by loosening the hex screw (13mm wrench required)
on the back of the cabinet that secures the motor.
4) Using snap ring pliers, remove the snap ring (B) that secures the lower wheel (C) to the
shaft (D).
5) Slide the lower wheel assembly off the shaft (D) which will dislodge the belt (A), discard the
old belt.
6) Place the new belt onto the lower wheel pulley.
7) Reinstall lower wheel assembly by sliding it back onto the shaft (D).
8) Replace snap ring (B).
Fig.11
Fig.12
