Email: [email protected] www.terratekintl.com
ACL Group (Intl) Ltd
14
Check the extension cable regularly and replace it if damaged.
Keep handles dry and free from oil and grease.
15. Always pull out the power plug:
When the tool is not being used, before carrying out any maintenance work and when changing
attachments such as blades, bits and cutters of any kind.
16. Remove adjusting keys and wrenches!
Make sure that all keys and adjusting wrenches are removed from the tool before switching it on.
17. Avoid unintentional starting!
Make sure that the switch is in OFF position when inserting the power plug.
18. When using an extension cable outdoors:
Check that it is approved for outdoor duty and is marked accordingly.
19. Be alert at all times!
Watch what you are doing. Use common sense.
Do not operate the tool if your mind is not on your work.
20. Check the tool for damage!
Each time before re-using the tool, carefully check that the guards or any slightly damaged
parts are working as intended.
Check that the moving parts are in good working order, that they do not jam, and that no
parts are damaged. Make sure that all parts are fitted correctly and that all other operating
conditions are properly fulfilled.
Unless otherwise stated in the operating instructions, damaged guards and parts have to be
repaired or replaced by an authorized service center.
Have damaged switches replaced by a customer service workshop.
Never use any tool if its switch cannot be turned off and on.
21. IMPORTANT!
The use of any accessory or attachment other than those recommended may involve a risk of
injury for you personally.
22. Have repairs carried out only by a qualified electrician!
This electric tool complies with the pertinent safety regulations. Repairs are to be carried out
only by a qualified electrician using original replacement parts or the user may suffer an
accident.
23. Wear safety gloves whenever you carry out any maintenance work on the blade!
24. In the case of mitre cuts when the table is tilted, the guide must be positioned on the lower
part of the table.
25. When cutting round wood, use a device to stop the workpiece from twisting.
26. When cutting boards in upright position, use a device to prevent kick-back.
