Email: [email protected] www.terratekintl.com
ACL Group (Intl) Ltd
20
90º Table Stop Adjustment
(Fig. 4)
Adjusting the table stop
The table stop (E) is typically set at 90º (perpendicular) with the blade.
1) Loosen lock knob (A) then tilt the table (B) down, bringing it to rest against the table stop (E).
2) Place a square on the table and against the blade to see if the table is 90º to the blade.
3) If an adjustment is necessary, tilt the table up to access the table stop (E).
4) Loosen the lock nut (C) and turn the table stop (E) in or out to raise or lower the stop.
Tighten the lock nut to hold the table stop in place.
5) Bring the table back to level, let it rest against the stop and confirm table is 90º with the
blade as described in step 3.
Adjusting the table tilt indicator
1) Set the table at 90º with the blade as described above.
2) Confirm that the table tilt indicator (F) in (Fig. 4) points to zero.
,IÛDGMXVWPHQWLVUHTXLUHG6OLJKWO\ORRVHQWKHVFUHZWKDWLVVHFXULQJWKHLQGLFDWRUDGMXVW
indicator to point to zero; then re-tighten the screw.
Changing Blades
(Fig. 5)
WARNING:
Blade teeth are sharp! Use care when handling the saw blade. Failure to comply
may cause serious injury.
1) Disconnect machine from power source.
2) Open both wheel covers (A).
3) Remove rip fence guide (E-Fig. 1).
4) Release tension on the blade by loosening the tension handle (A-Fig.6).
5) Remove blade (C) from upper and lower wheels (D,E) and from between the upper and lower
blade guides (F,G).
Fig.3
Fig.4
