Quick Start Guide
Choose Mounting Location
Mount Fill Sensor
Attach the Mounting Plate
Mounting Template
Removable Mounting Plate
Status Lights
Power Button
Speaker
Plastic Hooper
•
Attach the mounting plate with self drilling screws.
Metal Hopper
•
Using the included mounting template drill two 1/8 in holes and
remove center square.
•
Attach the mounting plate with sheet metal screws.
•
Match the screws in the Sensor with the slots in the
mounting plate and rotate counter clockwise to lock
the Sensor to the mounting plate.
•
Turn Sensor on after it is mounted to properly calibrate.
Indicates Battery Life and
Sensitivity Level
Find optimal mounting location on attachment.
Tips to determine mounting location.
•
Material must fall against wall where Sensor is mounted.
•
Near last location of where hopper fills.
•
No metals between Sensor and material.
•
Near fill tube.
•
Sensor must be charged prior to use to activate.
Scan Mode :
Sensor is searching for material to indicate hopper is full. Status lights will display the chase sequence.
Alarm Mode :
Buzzer will alarm, status lights will blink, buzzer will chirp every 15 seconds until hopper is emptied.
Sleep Mode :
Sensor will begin to sleep after a period of inactivity. Sensor will awake upon movement.
Sensitivity Level :
Press the power button multiple times to cycle through the sensitivity levels. Level 1 for wet grass, level 5 for dry leaves.
Power On/Off :
Press the power button until status lights turn on. Press and hold to turn off.
Charging :
Charge using included USB cable + AC adapter (Not included). Status lights indicate battery charge level.
Low Battery :
The buzzer will chirp twice every minute indicating the battery is low.
Cut
Cut
C
ut
C
ut
Dill 1/8 in
hole
Dill 1/8 in
hole
4
1 2 3
2 in square must be
removed from metal
hopper.
Drill 1/8 in
hole
Drill 1/8 in
hole
