Water supply 3/8” O.D. unplated copper
tube. Waste 1-1/4” IPS. Contractor to
supply waste trap and service stop valve
in accordance with local code.
Connecting lines to be made of unplated
copper and should be thoroughly flushed
to remove all foreign matter before being
connected to fountain. This fountain is
manufactured in such a manner that it
does not in any way cause taste, odor,
color, or sediment problems.
Connect fountain to supply line with a shut-
off valve and install a 3/8” unplated copper
water line between the valve and the
cooler. Remove any burrs from from outside
of water line. Push the tubes straight into
the fittings until they reach a positive stop,
approximately 3/4” (see figures 2 and 3).
DO NOT SOLDER TUBES INSERTED INTO
THE STRAINER AS DAMAGE TO THE
O-RINGS MAY RESULT.
These products are designed to operate on
20 psig to 105 psig supply line pressure. If
inlet pressure is above 105 psig, a pressure
regulator must be installed in the supply
line. Any damage caused by reason of
connecting this product to supply line
pressures lower than 20 psig or higher than
105 psis is not covered by warranty.
This fountain is to be mounted on a
smooth, flat, finished surface with
adequate support structure.
NOTE: Mounting structure must be
capable of supporting 300 lb. load on
fountain.
Refer to rough-in for plumbing.
Install shut-off valve on water supply.
(valve not furnished)
Locate and install fountain using 3/8”
minimum anchor screws or bolts.
(screws or bolts not furnished)
CAUTION: This fountain is rated for inlet
water pressure of 20-105 PSI. A pressure
reducing regulator should be used if the
inlet water supply exceeds 105 PSI.
Connect water supply and fountain drain.
Water connection & drain must comply
with local codes.
Turn on water supply and check all
connections for leaks.
1
1
2
2
3
3
4
4
5
6
GENERAL INSTALL TIPS
START UP
11 1/2”
292 mm
5 3/8”
137 mm
18”
457 mm
15 1/12”
394 mm
19 1/2”
495 mm
15 1/2”
394 mm
15 1/2”
394 mm
35 1/4”
895 mm
FIGURE 1
2
D F - 3 8 — O w n e r ’s M a n u a l
1 1/4”
32 mm
WASTE LINE
3/8”
10 mm
O.D WATER
INLET
IMPORTANT! INSTALLER PLEASE NOTE
Wall mounting structure must be capable of supporting 300 lb. load on fountain.
