71M6513/71M6513H Demo Board User’s Manual
Page: 66 of 112
©
2005-2006 TERIDIAN Semiconductor Corporation
Revision 5.6
Item #
Reference
Designator
Name
Use
9
SW2
RESET
Chip reset switch: The RESETZ pin has an internal pull up
that allows normal chip operation. When the switch is
pressed, the RESETZ pin is pulled low which resets the IC
into a known state.
10
SW1
Pulse Rate Select
Switch connected to DIO3 (non-functional in Demo Code).
SW1 should always be kept in the lower position.
11 JP9
EEPROM
Write
Protect
Three-pin header that allows selection of the write
protection or read/write capability for the EEPROM (U4) on
the demo board.
Default setting of the demo board is to
place a jumper between pin 1 and 2 of JP9
.
12 J12
Supply
and
Optical Test Point
Four-pin header. Terminals 1 and 3 can be used to
measure the supply voltage to the 71M6513/71M6513H IC.
Terminal 2 monitors the TX_OPT output of the IC. Terminal
4 monitors the OPT_RX input to the IC.
13
JP12
DIO Test Point
7-pin test point. For monitoring DIO15 to DIO21.
14
J2
DEBUG
Connector for Debug Board. 2x8 pin male header.
15
J10, J11
LCD
LCD connection. The LCD daughter board connects
between these two 2x12 header jumpers.
16
BT1
Battery Terminal
Two-pin header for connection of a 3.6V battery. The top
pin is the positive terminal and the bottom pin is ground.
17
JP8
VBAT Selection
Three-pin header that allows selection of power to the
VBAT pin. When the jumper is placed between pins 1 and
2
(default setting of demo board)
VBAT is tied to the IC
supply. When placed between terminals 2 and 3, VBAT is
powered by an external battery.
18, 19
TP17, TP18
Test Points
TMUXOUT and CKTEST test point.
20
J14
EMULATOR I/F
2x10 emulator connector port for Signum ICE ADM-51.
21 J13 Voltage
Connections
Five-pin header.
Connect jumper to the bottom two pins
as the default
.
22
TP7
VREFOUT
Two-pin header. The top terminal is VREF, the bottom
terminal is ground
23
TP10, TP9, TP8
V1, V2, V3 Test
Points
Two-pin headers that are the comparator voltage input test
points
. A jumper is required at TP10 from V3P3 to V1
for operation with emulator
.
Table 3-2: D6513T3B2 Demo Board Description
http://www.datasheetcatalog.com/
