Terex TSV-70, Operation And Maintenance Manual

Page: 72 / 90

7 MAINTENANCE
70
7.7 Hydraulic Oil Change
The hydraulic oil should be changed
every 1000 service hours. Before
beginning the procedure, make sure
the machine is in a clean working
environment. Take any necessary
measures to prevent dirt or debris from
entering the hydraulic system.
To change hydraulic oil and filter:
1.
Shut the machine down according to the procedure in section 5.13.
2. Allow the machine to cool, then release any residual pressure in the
hydraulic system by following the procedure in section 4.7 of this manual.
3. Remove the access panel on the bottom of the machine beneath the pumps
to access the hydraulic drain. Remove the plug to drain. (fig. 7.7-1)
4. Drain the used oil into a suitable catch container.
5. Dispose of the oil according to mandates.
6. Reinstall the drain plug and tighten. Reinstall the lower access panel.
7. Refill the hydraulic reservoir (fill point item 5) with Mobile DTE 10 Excel
Series 46 Hydraulic Oil (fig. 7.7-3).
Note: Observe the hydraulic oil level sight gauge (item 6) located on the rear of
the hydraulic reservoir to ensure that the level is correct (fig. 7.7-3). Once oil is
visible, fill slowly to avoid overfilling.
8. Once full, start the engine according to the proper starting procedure and
operate all hydraulic circuits to work any trapped air out of the system.
Then, check the oil level. If low, add oil as necessary until full.
7.7-1 7.7-2
1
2
6
Full
Low 5
7.7-3
3
4
Hydraulic oil can be both HOT and under pressure! Allow the machine to
cool thoroughly prior to performing any maintenance or service on the
hydraulic system to avoid the possibility of burns.